Quadex™ Qm-1S Restore - 60lb Bag
QM-1s Restore® is a Portland cement based, single component, high strength, fiber reinforced, shrinkage compensated cement mortar enhanced with a monocrystalline quartz aggregate. QM-1s Restore was designed to structurally repair deteriorated metal, concrete and masonry structures. QM-1s Restore delivers a monolithic one pass vertical surface application up to three inches in thickness by low pressure spraying or centrifugally casting.
CURING
Cure in accordance with current ACI and manufacturer recommendations
PROCEDURE
Prepare surface to be patched by removing unsound concrete, dirt, dust, oil and other debris using high pressure (min 3,500 psi | 241.3 bar) water blasting. Then rinse with potable water to remove all remaining dirt, sand and loose debris. This will provide a clean, damp surface to facilitate bond.
Use approximately .70 to 1.0 gallons (2.64 to 3.78 liters) of potable water per 60 lb. | 27.2 kg. bag of QM-1s Restore®. First add water to mixer, start the mixer and add QM-1s Restore until mortar is completely mixed.
Apply QM-1s Restore by low pressure spraying on vertical or overhead surfaces to a monolithic thickness of 1/2 to 3-inches | 12.7 to 76.2mm in one pass, trowel to smooth surface.
Features
- One 60 lb. | 27.2 kg. bag of QM-1s Restore will yield approximately 0.51 cu.ft. | 0.014 cu.m. and will cover 12.2 sq.ft | 1.13 sq.m. at a 1/2-inch | 12.7 mm thickness.
- Quality controlled, one-component blend for uniform results
- High early and ultimate compressive, flexural and bond strengths
- Resistant to sulfate attack
- Low permeability
| Model | QUAD-QM-1S |
|---|---|
| Brand | Quadex |
| Product Category | Epoxy Coatings |
| Industry Application | Coatings |